BC Set Installation Steps

NOTE: Using BC Sets to configure features is only available for demonstration system setup by TCT Partners. It should not be used for full system configuration.

Prerequisite

Ensure that a custom monitor is created beforehand, as it is required to associate with the BC Set activation.

The BC Set configuration assumes you are using the SAP MIME repository. If you are using an alternative repository, additional configuration steps maybe required.

Activating the BC Set

When activating BC Set ZTCTBCSETIDFC, input the values relevant to your setup.

Variable Field Values

NOTE:

After activating the BC Set, review the activation logs to confirm that the BC Set was activated successfully.

Activation Logs

Configuration Adjustments After BC Set Activation

Once the BC Set has been successfully activated, update the following:

Transaction /TCTM/ESV_IMAGE_CFG

For the MIME Not Available Image Path, use this to reference a “No Image Available” placeholder if you choose to display one.

Image Types

Example Image NO_IMAGE_AVAILABLE

For each image type, update the MIME storage settings with the new MIME base path you created.

MIME Storage Settings

Transaction /TCTM/EWM_CFG

Update the following transaction/step with the new parameter URL key as shown in the example below.

Logical Transaction	Logical Step / Screen
INSTPR	INSTPR
IVAHPR	IVMHUV
PI**** P	IBLMT
PI**** P	IMTTO
RH****	RHCHQT
RH****	RHHUDT
PI****	PIMTTO
PI****	PIPLHU

Logical Transaction / Step Extra Elements

Logical Transaction / Step Extra Elements Parameters